Testing & Commissioning
Our Testing & Commissioning Division ensures that electrical systems operate safely, efficiently, and in full compliance with international standards before being placed into service.
Our Testing & Commissioning Division ensures that electrical systems operate safely, efficiently, and in full compliance with international standards before being placed into service.
We perform primary and secondary injection testing, protection relay testing, transformer diagnostics, switchgear testing, SCADA and SAS integration, cable testing, functional verification, and system performance validation. Our experienced specialists deliver reliable commissioning services that minimize operational risks and maximize system reliability.
- Primary & secondary injection
- Protection relay testing
- Transformer & switchgear diagnostics
- SCADA & SAS integration
Our Services
- Pre-Commissioning & Commissioning Services
- Testing & Commissioning of Substations (Up to 132kV)
- Primary Injection Testing
- Secondary Injection Testing
- Protection Relay Testing & Calibration
- Protection Coordination Verification
- DC System Testing
- Cable Testing (HV, MV & LV)
- VLF, Hi-Pot & Insulation Resistance Testing
- Tan Delta & Partial Discharge (PD) Testing
- Cable Sheath Integrity & Continuity Testing
- Earthing System Resistance Testing
- Power Transformer Testing & Diagnostics
- Circuit Breaker Testing
- GIS & AIS Equipment Testing
- Switchgear Testing & Functional Verification
- Current Transformer (CT) & Voltage Transformer (VT/CVT) Testing
- Battery Bank & Charger System Testing
- SCADA Integration & Testing
- Substation Automation System (SAS) Testing
- IEC 61850 Configuration & Verification
- RTU & Communication System Testing
- Control & Protection Panel Functional Testing
- Interlock & Logic Verification
- End-to-End Signal Testing
- Synchronization & Energization Support
- System Performance Validation
- Site Acceptance Test (SAT)
- Factory Acceptance Test (FAT) Witnessing
- Troubleshooting & Fault Diagnosis
- As-Built Documentation & Commissioning Reports
- Operation & Maintenance Support
- QA/QC, HSE & International Standards Compliance (IEC, IEEE, SEC Standards)
Have a project in this sector?
Our technical team is ready to review your scope and propose the right solution.